Nokia M10 Bedienungsanleitung PDF herunterladen (Seite 105)

Nokia M10 User’s Manual

DRAFT

 Copyright Nokia Telecommunications Oy

NTC C33539002SE_A0

5-56

Command Set default gateway IP address

Description Specifies the IP address of the default IP gateway. Only

applies when the default gateway interface is

ip-ad-

dress

Syntax set ip gateway default [ip_address]

Arguments ip_address argument is the IP address of the default

gateway.

Example m10> set ip gateway default 191.233.22.1

Command Enable IP packet forwarding and route distribution

between ATM VCC interfaces

Description Enable/disable IP packet forwarding and route distribu-

tion between ATM VCC interfaces. If only one VCC is

used this option can be ignored.

Syntax set ip interwan-routing [on|off]

Arguments The argument enables/disables interwan routing.

Example m10> set ip interwan-routing on

Use the following commands to configure settings for routing IP over

PPP link.

Command Enable/disable routing IP over PPP link

Description Enables/disables IP routing through the specified logi-

cal ATM channel using ppp-vcmux encapsulation.

Syntax set ip ip-ppp {vccx} option [on|off]

Arguments The first argument identifies the ATM channel (vccx, x =

1 ... 8). If there is only one ATM channel using ppp-

vcmux encapsulation you can leave the argument vccx

out. The on/off argument enables/disables routing.

Example m10> set ip ip-ppp vcc1 option off

Note You must enable IP routing before you can enter other

IP routing settings for the serial port. If you turn off IP

routing and save the new configuration, the Nokia

M10 clears IP routing settings.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 161 162

Keine Kommentare

Nokia M10 Bedienungsanleitung Seite 105